How to quiet my sump down

  • Thread starter Thread starter Cory jones
  • Start date Start date
  • Tagged users Tagged users None

Cory jones

New Member
View Badges
Joined
Jan 18, 2019
Messages
12
Reaction score
3
What state or country do you live in
Illinois
Rating - 0%
0   0   0
I have a 60 display with shadow over flow it is fairly quiet. It is where the water goes into the sump a combination of air bubbles escaping and then it goes up over to the fillter socks. Most of the sound is the water dropping in the fillter socks. I would like to remove them but the noise is much worse with them out. Does anyone have any ideas?

13F7A67F-E139-47B5-873F-E688D539C0AE.jpeg


4D0FA5D3-DBEC-4CA0-9C3D-D006D0FBF57D.jpeg


C58E382D-0E49-4E84-95BE-CEB21E493225.jpeg
 
Reducing the amount of pipe below the water line at the inlets will let the siphon line purge the air better, and quiet the bubble noise. Assuming this is a 3-drain (siphon, auxiliary and emergency) there shouldn't be bubbles at all in the inlet.
Raising the overall water level by an inch or two should quiet down the splashing in the socks.
 
Water level in the sock area is too low. I'd add a flow over baffle wall an inch or so from the outside of the existing wall, a half inch or so lower than the top of the sock opening. Water level would raise to the top of the socks, waterfall noise should be all gone.
 
Reducing the amount of pipe below the water line at the inlets will let the siphon line purge the air better, and quiet the bubble noise. Assuming this is a 3-drain (siphon, auxiliary and emergency) there shouldn't be bubbles at all in the inlet.
Raising the overall water level by an inch or two should quiet down the splashing in the socks.

That’s what I was thinking but I still get bubbles. Raising the water does little to nothing unless I raise it to the top and can’t do that.
 
Water level in the sock area is too low. I'd add a flow over baffle wall an inch or so from the outside of the existing wall, a half inch or so lower than the top of the sock opening. Water level would raise to the top of the socks, waterfall noise should be all gone.
Good idea I will try that.
 
Did you ever figure out a solution to the noise without the socks?
 

TOP 10 Trending Threads

WHAT DO YOU ALWAYS RUN OUT OF AT THE WORST TIME?

  • Salt mix

    Votes: 15 18.1%
  • Fish or coral food

    Votes: 5 6.0%
  • Test kits or reagents

    Votes: 8 9.6%
  • Filter media or replacement fleece

    Votes: 4 4.8%
  • RO/DI filters or supplies

    Votes: 13 15.7%
  • Fragging and repair supplies, like glue or epoxy

    Votes: 10 12.0%
  • I keep a backup of everything

    Votes: 21 25.3%
  • Other (Post in the comments)

    Votes: 7 8.4%
Back
Top
Home
Post thread…
Market
What's new