How would you make Ocean revive lights better?

[Frank_Aaron]

Did you end up updating your layout? I have three of these about to go over my new setup, and am invested in seeing how this turned out.

 

[TJ Jiang]

Tagging alone

 

[-Aquaman-]

What do you all think? Its basically a slightly smaller SBreef light clone. lol LED's are so inexpensive I may just buy all new LED's since these lights are going on 4 years old.

Proposed new layout

Original layout

What layout did you end up using?

 

[Rbusta]

What layout did you end up using?

Wasn’t the original poster but I used this advice to replace the LEDs on my ocean revives. I’ve done a fair bit of soldering so it was relatively simple. Took me about an hour and a half total.

 

[Rbusta]

In the picture of the lights on the closer side had been replaced and the further side was the original layout still.

 

[BrandonS]

check out @telegram on instagram and you tube.

 

[Thaxxx]

SB Lights have 55 bulbs. They are advertised as 3 watts each as in 55x3 to get 165 watts.
I have had 6 of the SB Lights and none of them drew more than 110 watts at 100% output.
I suspect they are really only 2 watt bulbs. The math adds up.