ICP test results - help with aluminium

  • Thread starter Thread starter jdm85
  • Start date Start date
  • Tagged users Tagged users None

jdm85

Community Member
View Badges
Joined
Oct 2, 2019
Messages
55
Reaction score
10
What state or country do you live in
Canada
Rating - 0%
0   0   0
From the looks of my ICP test it’s looking like everything is good other than high levels of aluminium. Is this value high enough to cause possible issues

see attached

any suggestions

ADA911F0-2614-4542-B0E5-5E5415C9394E.png
 
I would say it is possible.

Potential sources that come to mind are as follows:

  • Aluminum oxide - used in PO4 reduction
  • Heard marine pure bio-block leach Aluminum, but no personal experience with said product, so can't confirm.
So far that is what comes to mind. Recommend water changes over time to aid.
 
I'm not sure it is high enough to be a problem (250 ug/L was OK in my tests, 500 ug/L was not), but it is substantial.

Are you using any white media of any sort?
 
Marinepure
But to release that amount of aluminum seems a bit high.

moral of the story all of my corals die or start to reseed

lights are not the issue as most of my soft corals sit in 150 par range max using xr15 gen5 so I wanted to do an icp test to see what’s going on
 

TOP 10 Trending Threads

WHAT DO YOU ALWAYS RUN OUT OF AT THE WORST TIME?

  • Salt mix

    Votes: 17 17.7%
  • Fish or coral food

    Votes: 5 5.2%
  • Test kits or reagents

    Votes: 10 10.4%
  • Filter media or replacement fleece

    Votes: 5 5.2%
  • RO/DI filters or supplies

    Votes: 15 15.6%
  • Fragging and repair supplies, like glue or epoxy

    Votes: 12 12.5%
  • I keep a backup of everything

    Votes: 25 26.0%
  • Other (Post in the comments)

    Votes: 7 7.3%
Back
Top
Home
Post thread…
Market
What's new