Is E6000 Safe for tank lid?

[gingeramoeba]

I’ve been looking around but can’t find a situation similar to mine. I made an lid for my tank and used E6000 to attach the mesh to the plexiglass. Is this glue safe after it has cured to put above the water surface? Thanks!

*I hope I posted in the appropriate forum.

 

[blaxsun]

Probably. It's not going to be submerged in the tank so I would think it would be fine (even under any lights).

 

[gingeramoeba]

That’s what I’m hoping. I was more worried about water splashing on it and going back in the tank. I feel so stupid for not checking before I glued it. Super glue wasn’t holding and I just had the E6000 laying around and was more concerned with it sticking than being safe. Oof. Thanks.

 

[Randy Holmes-Farley Verified Community Expert]

I do not see any ingredients listed that are a concern in the water, once it has dried.

 

[gingeramoeba]

I do not see any ingredients listed that are a concern in the water, once it has dried.

Thanks @Randy Holmes-Farley !