I missed my chance to buy it, so I'm going to diy it. Any knowledgeable engineers out there know if this valve is reef safe?
Body Material: PA66 Nylon Plastic
Seal Material: NBR (Buna N) Diaphragm & Plunger Tip
It looks like the body is nylon, will this crack/become brittle with repeated exposure to salt water?
Seal is made out of nitrile, so I think that's reef safe?
Other options I looked at were the anticorrosion solenoid on the same website but their rep said it needed a minimum pressure of 5psi to be safe to open and I checked out an actuated ball valve from another site that was close to $140.
Body Material: PA66 Nylon Plastic
Seal Material: NBR (Buna N) Diaphragm & Plunger Tip
It looks like the body is nylon, will this crack/become brittle with repeated exposure to salt water?
Seal is made out of nitrile, so I think that's reef safe?
Other options I looked at were the anticorrosion solenoid on the same website but their rep said it needed a minimum pressure of 5psi to be safe to open and I checked out an actuated ball valve from another site that was close to $140.