Jebao pp-4 wave maker in 32g Biocube

[Aidanwolf]

Hello I have a Jebao pp-4 wave maker in my 32g BIocube and I am trying to figure out the best setting and location. Right now it is set on the Else mode on the lowest speed, but it is still blowing some sand around.

 

[Rickyb1982]

Hello I have a Jebao pp-4 wave maker in my 32g BIocube and I am trying to figure out the best setting and location. Right now it is set on the Else mode on the lowest speed, but it is still blowing some sand around.

Did you try pointing it upwards a little ?

 

[cmcoker]

Else mode is not controlled by the speed. It ramps between high and low disregarding the speed setting.. unless they have changed something recently

 

[Aidanwolf]

Did you try pointing it upwards a little ?

It is pointed upwards, I am not sure if I can point it up more or not.

 

[Aidanwolf]

Else mode is not controlled by the speed. It ramps between high and low disregarding the speed setting.. unless they have changed something recently

I am not sure I was just messing with the modes.

 

[Rickyb1982]

I am not sure I was just messing with the modes.

Yea I would probabaly just put it on pulse mode set low

 

[Jonreefer]

in any of the Jebao pumps. Else mode is a random mode that you really cant control anything of speed or time. its all random from Min to 100% speed
I had 2 PP4 in my old 35 cube and I had one lower in the tank pointing up and another higher pointing flat. I notice the more surface agitation the more it seem to move the sand. Since moving the surface water seems to up the flow in the tank from it moving around