Kalkwasser damage to acrylic media reactor
- Thread starter imustbenuts
- Start date
- Tagged users None
salty joe
Well-Known Member
Acrylic should hold up, I wonder if it was polycarbonate.
BTW, the driveway marker that I used as the stirring rod was attacked by the kalk. I hadn't run the stirrer for a week or so and the orange color from the driveway marker was bleeding into the kalk! I rebuilt using a PVC rod. Kalk is also hard on silicone.
Nylon and PVC are both good to use with kalkwasser.
BTW, the driveway marker that I used as the stirring rod was attacked by the kalk. I hadn't run the stirrer for a week or so and the orange color from the driveway marker was bleeding into the kalk! I rebuilt using a PVC rod. Kalk is also hard on silicone.
Nylon and PVC are both good to use with kalkwasser.
dantimdad
7500 Club Member
Hate to dredge up and old topic, but, I built an acrylic reservoir over the weekend out of cast acrylic in clear and white. It was assembled with weldon 4 and it currently leak testing.
Will kalk affect the acrylic? I plan on mixing in a separate bucket and then draining it into the reservoir to avoid precipitate in the ATO container.
In the past I used 5 gallon buckets and never had an issue other than power heads don't last as long pumping kalkwasser as they do in RODI water.
Appreciate any input.
Will kalk affect the acrylic? I plan on mixing in a separate bucket and then draining it into the reservoir to avoid precipitate in the ATO container.
In the past I used 5 gallon buckets and never had an issue other than power heads don't last as long pumping kalkwasser as they do in RODI water.
Appreciate any input.
Similar threads
-
- Poll
