Kalkwasser on ATO or Dosing 2 part?

  • Thread starter Thread starter Laborator
  • Start date Start date
  • Tagged users Tagged users None
I use both. Kalk alone was great for a while but wasnt enough for long. I would use two part alone but I love the bump kalk gives to my low PH
 
So far my Calc has gone through the roof, PH too high, and Alk has stayed low. I think I may go back to 2-part. I'm going to try and mix less Kalk on my ATO next time and see. My $.02
 
Check your ph to see if you can even use kalkwasser because it has a very high ph.
Some two part can actually push up ph too.
 
Check your ph to see if you can even use kalkwasser because it has a very high ph.
Some two part can actually push up ph too.

My tank usually runs a little low to normal PH with 2-part. I only noticed a high PH when I started Kalk on my ATO. I'm going to try and mix less i.e. just mixt 5 tsp on a 5 gal container and see.
 
I prepared a new batch of ATO with 5 tsp of Kalk and saw no spike in PH this time. I still see that my alk goes down but Calcium stays high. I just don't see the point in Kalk is all it does is maintain high Calcium and not alk. I can 2-part both since I have to add alk all of the time. Maybe it's just me but I don't see the benefit of Kalk.
 
I prepared a new batch of ATO with 5 tsp of Kalk and saw no spike in PH this time. I still see that my alk goes down but Calcium stays high. I just don't see the point in Kalk is all it does is maintain high Calcium and not alk. I can 2-part both since I have to add alk all of the time. Maybe it's just me but I don't see the benefit of Kalk.

If all your parameters are within the correct ranges than Kalk will keep them there as it is a balanced additive. If your calcium is too high it can make it harder to keep alk up. Here is a great article on the subject.

Chemistry And The Aquarium: Solving Calcium And Alkalinity Problems
 
You just have to find out how much Kalk to mix and a dosing pump would allow you to control how much you add a day. I am using a 3 gallon per day max pump, so if I need to crank it up to keep up with evaporation I can't go past 3 gpd. I used to use a float valve and it worked but the line would get clogged with calcium occasionally and I was worried that the valve could hang open.

I use a Kent float valve in a bucket with a small power head to keep the water moving. The bucket is connected to a dosing pump. The line from the dosing pump goes into the sump.
The bucket/"kalk reactor" is filled from my RO unit through the float valve.
 
Last edited:

TOP 10 Trending Threads

HOW WOULD YOU FEEL ABOUT RECEIVING A FISH OR CORAL AS A HOLIDAY GIFT?

  • I’d love one, as long as it’s a species I chose

    Votes: 26 24.1%
  • I’d trust someone who knows my tank to choose

    Votes: 9 8.3%
  • I’d rather get a gift card and pick it myself

    Votes: 44 40.7%
  • I’d prefer gear or supplies instead

    Votes: 2 1.9%
  • Please don’t surprise me with livestock

    Votes: 27 25.0%
  • Other (Post in the comments)

    Votes: 0 0.0%
Back
Top
Home
Post thread…
Market
What's new