Kessil 360 WE burnt by wrong power supply?

Glad you got it figured out!
 
I ran into this problem less than a month ago with the exact same light. Except I was provided with a known dead power supply.

Back in the day I used to repair computers so I’m pretty familiar with small electronics and I also remembered that most older laptop power supplies are 19 V 4.62 amps 90 W. That is exactly the same Voltage output of the Kessil PS. I grabbed an old Dell power supply checked it with a meter. I was good to go so I cut the end off Dell PS because it was too big for the Kessil. I put the Kessil end on the Dell PS and it works like a charm.

Obviously, please don’t mess with wiring if you’re not sure about what you’re doing. Unplug everything and move it away from the aquarium and to a workbench.

Good luck.
 
Yup - that would be perfectly safe assuming the splice is correct

19v supply to 19v device
4.6a supply to device needing less than 4.6a
 

TOP 10 Trending Threads

WHAT DO YOU ALWAYS RUN OUT OF AT THE WORST TIME?

  • Salt mix

    Votes: 6 17.6%
  • Fish or coral food

    Votes: 3 8.8%
  • Test kits or reagents

    Votes: 3 8.8%
  • Filter media or replacement fleece

    Votes: 3 8.8%
  • RO/DI filters or supplies

    Votes: 5 14.7%
  • Fragging and repair supplies, like glue or epoxy

    Votes: 5 14.7%
  • I keep a backup of everything

    Votes: 7 20.6%
  • Other (Post in the comments)

    Votes: 2 5.9%
Back
Top
Home
Post thread…
Market
What's new