Kessil 360 WE burnt by wrong power supply?

Glad you got it figured out!
 
I ran into this problem less than a month ago with the exact same light. Except I was provided with a known dead power supply.

Back in the day I used to repair computers so I’m pretty familiar with small electronics and I also remembered that most older laptop power supplies are 19 V 4.62 amps 90 W. That is exactly the same Voltage output of the Kessil PS. I grabbed an old Dell power supply checked it with a meter. I was good to go so I cut the end off Dell PS because it was too big for the Kessil. I put the Kessil end on the Dell PS and it works like a charm.

Obviously, please don’t mess with wiring if you’re not sure about what you’re doing. Unplug everything and move it away from the aquarium and to a workbench.

Good luck.
 
Yup - that would be perfectly safe assuming the splice is correct

19v supply to 19v device
4.6a supply to device needing less than 4.6a
 

TOP 10 Trending Threads

WHICH PART OF YOUR SETUP IS HARDEST TO REACH OR REMOVE FOR ROUTINE MAINTENANCE?

  • Glass behind or beside the tank

    Votes: 2 13.3%
  • Powerheads or wavemakers

    Votes: 2 13.3%
  • Sump or rear filtration chambers

    Votes: 2 13.3%
  • Skimmer or other filtration equipment

    Votes: 1 6.7%
  • Overflow or plumbing

    Votes: 5 33.3%
  • Lights or lids

    Votes: 0 0.0%
  • Mine is pretty easy to access!

    Votes: 2 13.3%
  • Other—tell us what I missed

    Votes: 1 6.7%
Back
Top
Home
Post thread…
Market
What's new