Kessil Housing Screws... screwed up :(

  • Thread starter Thread starter Meldrath
  • Start date Start date
  • Tagged users Tagged users None
Also with easy-outs(reverse spinning drill bits), you need to tap the screw head a bit so the tip of the easy-out bites into the screw. They usually will include a metal cutting drill bit in the kit. You want to use a drill bit that is 2 times smaller then the easy-out size. Then very slowly(they work better by hand with a T style handle like above) turn counter clockwise and it should work it's way out.

I also find that unless your using the easy-outs on hardened bolts, doing it by hand is loads better then using a drill.

FWIW, I have used vice grips on some of my easy-outs that do not fit in my T handle(they typically have square heads).
 
Broke down and bought a Ridgid 'dremel' and was able to cut the housing where I thought I would and cut the screw in half.

Also identified why the screw was so hard to remove in the first place. Salt creep has caused rust and probably caused the threads to seize up.

20200103_221543.jpg


20200103_221555.jpg
 

TOP 10 Trending Threads

WHAT DO YOU ALWAYS RUN OUT OF AT THE WORST TIME?

  • Salt mix

    Votes: 17 18.9%
  • Fish or coral food

    Votes: 5 5.6%
  • Test kits or reagents

    Votes: 9 10.0%
  • Filter media or replacement fleece

    Votes: 5 5.6%
  • RO/DI filters or supplies

    Votes: 14 15.6%
  • Fragging and repair supplies, like glue or epoxy

    Votes: 10 11.1%
  • I keep a backup of everything

    Votes: 23 25.6%
  • Other (Post in the comments)

    Votes: 7 7.8%
Back
Top
Home
Post thread…
Market
What's new