LLS and ATO Programming

[paradizecityz]

I have a liquid level sensor in my sump. If I want to code my ATO to turn off if sump level is higher then certain number, is it as simple as below?

Fallback OFF
Set ON
If Sump > 8.0 Then OFF

If I do Set OFF, my ATO is off even though level is lowering than 8.0

 

[blaxsun]

You probably want to add:

If Sump <7.5 Then ON

 

[paradizecityz]

You probably want to add:

If Sump <7.5 Then ON

Oh ok, I thought it would always be on except when Sump > 8.0....I'll give it a try tomorrow, thanks!

 

[blaxsun]

Oh ok, I thought it would always be on except when Sump > 8.0....I'll give it a try tomorrow, thanks!

I haven't played with the LLS yet, so I'm just guessing that it works with decimals. But yeah, anytime you have a > command you need a corresponding < to set it back to the other desired state.

 

[paradizecityz]

I haven't played with the LLS yet, so I'm just guessing that it works with decimals. But yeah, anytime you have a > command you need a corresponding < to set it back to the other desired state.

Thanks! Didn't know that. I hope it works with decimals lol. But it should since the graph is in decimals.
I guess if I want it always on, I would do If Sump <7.9 Then ON

 

[blaxsun]

Thanks! Didn't know that. I hope it works with decimals lol. But it should since the graph is in decimals.
I guess if I want it always on, I would do If Sump <7.9 Then ON

Yes. Those new LLS look interesting - looking forward to getting one for my RO reservoir.