Loads of Flow in a Large Cube

  • Thread starter Thread starter Biglurr54
  • Start date Start date
  • Tagged users Tagged users None
Well I have the tank up and cycling and the flow has been decided on. I went with two gyre 3ks. They are on either end pointed at each other. They run for 90 minutes independently with 15 minutes of overlap.

On the back wall I have an mp40qd on either side of the overflow. They are set to 75% on reef crest.

It's alot of flow but fully controllable and should meet my needs as the tank grows into itself.
 
Photo
e5f7d2d92da11d146efec24a320136eb.jpg
 
Well I have the tank up and cycling and the flow has been decided on. I went with two gyre 3ks. They are on either end pointed at each other. They run for 90 minutes independently with 15 minutes of overlap.

On the back wall I have an mp40qd on either side of the overflow. They are set to 75% on reef crest.

It's alot of flow but fully controllable and should meet my needs as the tank grows into itself.
How did it come along? Looking at a similar tank and trying to figure out flow.
 
I cant recommend they gyres enough! I ended up with 4 xf250s running at about 30-40% pulsing. I have 2 mp40s on the back wall still but they are pounding my sps. I have them set at reef crest at 30%. There are no dead spots and everything gets turned over well. There are good areas of lower flow in the middle for LPS. This is more a factor of the rock work than the pump placements but gyres do create a slower flow in the middle of the tank.

If your on a tighter budget go with Jebao crossflows for now and dont do the mp40s on the back wall. I tried 2 of jebao's largest gyres. It worked alright but you are better off with 4 smaller gyres. 4 3ks turned down to 65% would fit the bill perfectly. Two xf250s werent moving much on the outside edges of the tank so i added an extra two and it is perfect.
 

TOP 10 Trending Threads

WHAT DO YOU ALWAYS RUN OUT OF AT THE WORST TIME?

  • Salt mix

    Votes: 17 18.5%
  • Fish or coral food

    Votes: 5 5.4%
  • Test kits or reagents

    Votes: 10 10.9%
  • Filter media or replacement fleece

    Votes: 5 5.4%
  • RO/DI filters or supplies

    Votes: 14 15.2%
  • Fragging and repair supplies, like glue or epoxy

    Votes: 10 10.9%
  • I keep a backup of everything

    Votes: 24 26.1%
  • Other (Post in the comments)

    Votes: 7 7.6%
Back
Top
Home
Post thread…
Market
What's new