- Joined
- Jan 31, 2019
- Messages
- 369
- Reaction score
- 166
I have posted this on the GHL Facebook page, but thgouht I would post here as well.
My skimmer stopped running yesterday (due to be fouled). Normally it had 0.5A current draw on the power bar. Is there a way of monitoring and alerting if current draw is outside of a nominated window (either high or low)?
Low - obvious use case is when a pump stops running.
High - something variable might be running harder than it should (possible to pick up on a 1-10v output if you are using Profilux to control, but may be useful where Profilux isn't be used to control). An example might be a DC return pump pumping harder than it should.
Thanks in advance
My skimmer stopped running yesterday (due to be fouled). Normally it had 0.5A current draw on the power bar. Is there a way of monitoring and alerting if current draw is outside of a nominated window (either high or low)?
Low - obvious use case is when a pump stops running.
High - something variable might be running harder than it should (possible to pick up on a 1-10v output if you are using Profilux to control, but may be useful where Profilux isn't be used to control). An example might be a DC return pump pumping harder than it should.
Thanks in advance