Mp10 problem

[Dub]

I have 2 mp10 that have a problem. On the wet side When you remove the cage for cleaning the propeller mount has three plastic clips that snap onto the base raising the clips slightly allows you to lift the propeller off the ceramic post/bear shaft. My problem is that after cleaning and reassembling when I try to install the wetside I get chattering and the propeller unit detaches from its base. Is there a solution to this problem? Thanks

 

[Cwentz758]

Are you making sure the tip of the propeller goes in the hole in the middle of the cage before twisting it onto the base? The cage should twist down not snap really

 

[Dub]

Yes the ceramic tip is in the hole in the center of the cage. The propeller unit snaps into the recess for it in the base and the cage is fitted over the ceramic post tip and twisted into place.

 

[Dub]

Bump

 

[Cwentz758]

You can also email ecotech they usually will get back to you the next day. They helped with my questions in the past