MP10 QD Bearing Replacement/Recommendation

[jmichaelh7]

Ya. You can email them and chat. They’re response is writhing a day. They’ve been great helping me with any issue I’ve had

Have you had luck doing this to replace bearing ?

 

[Cwentz758]

Have you had luck doing this to replace bearing ?

My issue ended up being the wetside.

They always wanted me to test the dry side by powering it on without the wetside and listen for the noise I had. I’m assuming just to narrow things down.
I would email them with your issue and see if they would replace a bearing vs buying a new dry side.
There are YouTube videos out there of people replacing the bearings

 

[dank reefer]

MP10 dry side started to make noise after it fell off the tank and I emailed ETM to see fi they what the cost would be to repair it, and they said that they would not repair, but replace the motor.

 

[jmichaelh7]

Do you have number I can contact them

MP10 dry side started to make noise after it fell off the tank and I emailed ETM to see fi they what the cost would be to repair it, and they said that they would not repair, but replace the motor.

 

[dank reefer]

Do you have number I can contact them

First .. Start by filling out a service request by following this link below. They will contact you within 24 or less with suggestion on what they might be able to do with whatever problem you have.
http://ecotechmarine.com/support/request-service/

 

[jmichaelh7]

Aw mines out of warranty.
Anyone know how to replace bearings on the new Mp10QD

 

[dank reefer]

Aw mines out of warranty.
Anyone know how to replace bearings on the new Mp10QD

Id still contact them even if its out of warranty. You never know what they would be able to offer you.

 

[Cwentz758]

Sometimes even out of warranty depending the issue if it’s a defect of the product or something non normal they may replace it.

 

[daniel16reefer]

The front or small bearing is 15x6x5 mm
The rear bearing or big bearing is 19x6x6 mm
(od x id x w)

They are both pressed to lock, not easy to remove. The rear bearing is very close to the magnet cylinder like 1mm space between them.

Did you end up buying the bearing for your pump? Where did you get it?

I have an MP10 QD that has some humming noises from the dry side as well. It make the wets side rattle a little but wet side appeared solid when I opened it up. I'm looking to open it up and check the bearing but want to make sure I buy the right replacement.

Thank you