MP10WQD and ReefLink

[Lukejstn]

Just got my reeflink last night and i only had a few mins to set it up before leaving for the night. I went through the steps of getting the Ecosmart live account, started the reset process on the MP10, and it got stuck on one of the last steps. So i unplugged it and started over, then on the instructions on my computer I read a little more and on the bottom it says "*This wizard is not intended for use with Quiet Drive VorTechs". This can't be correct, right? I was frustrated and late so i left for the night and haven't touched it since then.

 

[Lukejstn]

Update. I am trying this again and when it gets to the point of updating the firmware it flashes green and blue like it should but after a min or 2 it starts flashing red and blue. Anyone know whats going on?

 

[Lukejstn]

Ok i figured it out. I guess one is able to buy a wireless MP10 that is not fully wireless. I am missing the RF module. $50+ later its being shipped.