Mp40 anti sync programming

[ChadmRoman]

Ok so not really understanding the anti sync for the mp40’s. The Image below is my master setup. If I set anti sync 100% on the slave does the pump do the reverse of what’s shown? For instance at 11:27 the master runs 54% nutrient does the slave run nutrient starting g at 35%?

 

[homer1475]

From my understanding, intensity stays the same, they just ramp up and down in different patterns.

Like if the master was ramping up, the anti sync slave would be ramping down, and vice versus.

FYI, the intensity % you set is only the maximum percentage, they pump can run from anywhere from 25%(lowest intensity they will run, AKA feed mode) to your set percentage.

In your settings the 5% and 10% setting will result in the pump being off.

 

[ca1ore]

I still program mine using profiles and written out commands (versus using the wizards). You can set the following pump to any intensity you want and it does the inverse of the master at that intensity.