Multiple 4Level Cards?

[aggieoil11]

On my P4 system I have a 4Level card installed in my Expansion Box which was working fine until I realized I needed more level sensors on the P4 and added a 4Level card to the P4. Now the level sensors on the 4Level in the Expansion Box aren’t registering. Is there a maximum number of level sensors or does the system not allow two 4Level cards to be attached?

 

[Lasse]

As I understand - yo can have max 16 sensors. The p4 have 4 as standard and the exp box 2. An expansion card hav 4 - it sums up to 10 - yes it should work with 2 expansion cards IMO @Vinny@GHLUSA

Sincerely Lasse

 

[Gaël]

As I understand - yo can have max 16 sensors. The p4 have 4 as standard and the exp box 2. An expansion card hav 4 - it sums up to 10 - yes it should work with 2 expansion cards IMO @Vinny@GHLUSA

Sincerely Lasse

yes, I have P4 with ExpBox1 and 2 PLM-4LEVEL cards.

 

[Ditto]

Are you sure they see now working or that they shifted because you added a second one inside the P4?

 

[aggieoil11]

I removed the expansion box from the system and reassigned it to the system. It saw all level sensors then. Must have been because I added the 4Level to the EB first and the. The one in the P4 later. Thanks all.

 

[AquaLifeStudio]

I've had a similar issue with three expansion cards connected to an Expansion Box 2. Only 5 of our 9 level sensors register so I'm going to reset the Profilux back to factory defaults to see if that fixes the issue.