Heres how it is today finishing the skin. Anyone have ideas on how to set up the controls on the right side? Don’t want to just mount them on the back wall.
Still deciding on stain. I never stained birch wood before did a couple test pieces and didn’t like it grain came out blotchy after researching think I’m going to have to do some pre-stain with gel stain. If anyone has any suggestions I’m open wanting to do a dark stain. Did get sanding done light strip done and put sump and skimmer back.
Haven’t updated this in awhile. Since last post I made the doors. Adding fans to the back on the stand. Still need to clean up wiring a little. Need to hard plumbed my uv sterilizer. Been looking at ideas on how to run some air lines to garage for AWC and RO.