Needing very high pressures with carbon doser?

  • Thread starter Thread starter Eder
  • Start date Start date
  • Tagged users Tagged users None

Eder

Well-Known Member
View Badges
Joined
May 11, 2016
Messages
741
Reaction score
366
Rating - 0%
0   0   0
Having to run it around 12-15 to even get bubbles in reactor. I have a dannerle check Valve. When ran at high rates I do get bubbles however they do not seem to be consistent with the rate such as if I have it at 1 per 4 seconds I get 3-4 per 4 seconds likely because of the high pressure.

This is the valve I’m using.
IMG_1228.jpg
 
When mine got to where I needed really high pressure (30+), my regulator was rusty. I move the Carbon Doser box to a different regulator and it worked great again. That being said, 15-20 is about where I run mine.
 
Ps. Yes I did triple check the valve to make sure that I had it installed in the correct direction.
 
The me flew the input so far. My gauge only goes to 15 so almost maxing it out seemed unreasonable but maybe it isn’t.

My old gauge I used to run at 20. But it wasn’t a carbon doser.
 

TOP 10 Trending Threads

WHAT DO YOU ALWAYS RUN OUT OF AT THE WORST TIME?

  • Salt mix

    Votes: 17 18.9%
  • Fish or coral food

    Votes: 5 5.6%
  • Test kits or reagents

    Votes: 9 10.0%
  • Filter media or replacement fleece

    Votes: 5 5.6%
  • RO/DI filters or supplies

    Votes: 14 15.6%
  • Fragging and repair supplies, like glue or epoxy

    Votes: 10 11.1%
  • I keep a backup of everything

    Votes: 23 25.6%
  • Other (Post in the comments)

    Votes: 7 7.8%
Back
Top
Home
Post thread…
Market
What's new