Neptune Apex & Sicce SDC

[Comic_Reef]

Good afternoon,

Curious if anyone has a strange issue with Sicce SDC Pump and Neptune Apex.

After following all instructions to hooik up a Sicce SDC Pump I set the pump settings to a constant stste in the schedule with a stable 15%. However if I peek back into the Sicce ContAll app, the pump shows it is in Lagoonal Ripple mode at 15% this results in a slight up and down ramp from the pump. While its a small amount it has made dialing in a quiet overflow quite difficult.

I'm either having to set the peak to sit below the emergency drain with the valley causing noise OR I have to set the peak above the emergency drain and making noise and the valley quiet.

This has been driving me crazy. Anyone have any ideas here?

 

[n2585722]

Go into the Sicce App and set the pump mode to no mode.

 

[Comic_Reef]

Go into the Sicce App and set the pump mode to no mode.

This does not work for me. Whenever I set it to No Mode in the Sicce App it will set it to that setting for a few minutes before automatically returning back to Lagoonal Ripple

 

[n2585722]

This does not work for me. Whenever I set it to No Mode in the Sicce App it will set it to that setting for a few minutes before automatically returning back to Lagoonal Ripple

It was worth a shot. With the Hydros it does not set a mode except to no mode so you have to set the mode with the Sicce app if you want something other than no mode.