Neptune AWC and Top Up

  • Thread starter Thread starter MPSU
  • Start date Start date
  • Tagged users Tagged users None

MPSU

New Member
View Badges
Joined
May 29, 2023
Messages
6
Reaction score
0
Location
england
What state or country do you live in
Other International
Rating - 0%
0   0   0
Hi,

I am new to Apex, so apologies if this has been asked/answered already.

I have configured the AWC using the @SuncrestReef tutorial guide (great stuff, thank you).

I would ideally like my water changes to happen Monday - Friday, and I think I can do this using the DOW command, but at the same time would like to add a daily small amount of salt water (from my clean reservoir only) to replace that used by auto tests . Is this possible to do?

If it helps, I could look to exclude the DOW, and just do smaller changes each day, and then have the manual add from the clean reservoir each day too? This is so that I can replace water from the auto tests I am doing …

Thanks for any help!
 
Last edited:
Yes under advanced you can exclude Sat and Sunday from the DOW water change
If DOW S-----S Then ON

also you can set up a profile for dosing pump to add however many ML back to your tank per day.
 
Yes under advanced you can exclude Sat and Sunday from the DOW water change
If DOW S-----S Then ON

also you can set up a profile for dosing pump to add however many ML back to your tank per day.
 
Thanks for this.

Just do in understand, @Jason_MrFrags, if I add this line of code for DOW, will this apply to both the auto water change and also to manual dose? If so, that’s great? But how do I add the manual addition of clean salt water only l, leaving the AWC running as it was set by the Tasks wizard?

Thanks again!
 
I think you could set up a profile for the manual dose of NSW, then add a "If Time" statement to run the profile at your chosen time.

I also use DOW in my AWC. Mine is not set up with the task/wizard, I used manual profiles so my code will look a little different. My code (below), allows my AWC to run for 24 hours on Saturday only. The profile is setup to change out about 5 gallons in that time. I can also change 1 gallon at a time with the Feed D button (time set for 5 hours).
 

Attachments

  • AWC code.jpg
    AWC code.jpg
    124.7 KB · Views: 49
  • AWC Profile.jpg
    AWC Profile.jpg
    86.5 KB · Views: 44
That is super helpful. Thank you so much for your help. With give it a try!
 

TOP 10 Trending Threads

IF ONE SYSTEM FAILED WHILE YOU WERE AWAY, WHICH WOULD WORRY YOU MOST?

  • Power or backup power

    Votes: 14 30.4%
  • Heating or cooling

    Votes: 2 4.3%
  • Auto top-off

    Votes: 3 6.5%
  • Return pump or water circulation

    Votes: 4 8.7%
  • Dosing or automated testing

    Votes: 0 0.0%
  • Plumbing, overflow, or leaks

    Votes: 5 10.9%
  • Tank sitter or remote monitoring

    Votes: 2 4.3%
  • Electrical failure of some sort

    Votes: 1 2.2%
  • Seam or structure failure

    Votes: 12 26.1%
  • Something else (tell us in the comments)

    Votes: 3 6.5%
Back
Top
Home
Post thread…
Market
What's new