Nero 3 placement for GSP on back wall

[klr0808]

Hey everyone, so I have some tank updates. I did move the rock around a little bit. I also added a small toadstool leather and a strip of GSP on the back wall. However, I glued the gsp and I’m realizing I might not have the right wave maker set up to get flow to that back wall.

I have the Nero 3 on the right wall. I have RFG‘s and a mighty jet 538.The nero 3 doesn’t angle any, so I can’t really shift it towards the GSP. The toadstool is really happy after a couple of hours in the tank, but the GSP doesn’t look like it’s getting any flow. since the GSP is on the left lower wall, what’s the best way to try to get some flow to it without putting a wave maker directly across on the front

 

[Rocks reef]

Can you see the GSP moving in the current at all? If so, then the flow is fine. If you want more movement on the GSP, you could increase flow or move the powerhead.

 

[klr0808]

Can you see the GSP moving in the current at all? If so, then the flow is fine. If you want more movement on the GSP, you could increase flow or move the powerhead.

I do see the few polyps that have popped out moving so I guess it’s fine.