New Neptune APEX LD-3 Leak detection sensor

  • Thread starter Thread starter AquAttila
  • Start date Start date
  • Tagged users Tagged users None

AquAttila

Active Member
View Badges
Joined
Jun 9, 2018
Messages
324
Reaction score
163
What state or country do you live in
New Jersey
Rating - 0%
0   0   0
Guys, I had purchased one of these new and improved (so they say) APEX leak detection sensors from BRS. I plugged into my FMM module and immediately shows in "OPEN" state. I thought that was strange and tried putting it into a cup w/ water.... no change in state. BRS sent me another one without question. When I received the new one, it is the same thing. I opened a ticket with neptune 3 days ago and no status - very disappointed with these guys and support. Anyway, I don't know if anyone else had experienced this and perhaps it is a firmware update to FMM module, perhaps?
 
Thanks! let me give that a try as I did not know I need to set port in the apex dashboard to leak detection.
 
Open is dry - Closed is wet. Do you have the FMM set for leak detection on that port?
Thank you!! changing this in the dashboard seemed to do the trick. First leak sensor I installed, and had no idea that changing the type of sensor is required.
 
Thank you!! changing this in the dashboard seemed to do the trick. First leak sensor I installed, and had no idea that changing the type of sensor is required.
No problem at all. It's a really nice sensor (and an improvement over the older model).
 

TOP 10 Trending Threads

WHAT DO YOU ALWAYS RUN OUT OF AT THE WORST TIME?

  • Salt mix

    Votes: 17 18.5%
  • Fish or coral food

    Votes: 5 5.4%
  • Test kits or reagents

    Votes: 10 10.9%
  • Filter media or replacement fleece

    Votes: 5 5.4%
  • RO/DI filters or supplies

    Votes: 14 15.2%
  • Fragging and repair supplies, like glue or epoxy

    Votes: 10 10.9%
  • I keep a backup of everything

    Votes: 24 26.1%
  • Other (Post in the comments)

    Votes: 7 7.6%
Back
Top
Home
Post thread…
Market
What's new