Nicrew hyperreef bracket system

[BabuReef]

Hey everyone, since after one and half year of use and great results I'm planning to buy 2 extra 100W Nicrew hyperreef lights for my 60gal tank currently on cycle.
I don't want to drill the ceiling for suspended lights or add some kind of wall shelf, also I don't want to use original brackets since I want to set lights vertically rather than horizontally so I was asking myself: is there any bracket system like the Radion XR30 bracket mount for the hyperreef? Anybody who can tell me the length between the screw holes of XR30? If the screw holes matches the same length I would buy a multi light slide bracket for XR30
Thanks in advance

 

[blaxsun]

I measured this once before but can't remember the dimensions. If you PM me as a reminder I'll get the measurements for you. Just XR30 or did you want the XR15 also?

 

[BabuReef]

Hey, both are just fine thanks! Still unsure how to move, but if doesn't work for me I'll just stick making a bracket system specifically designed for nicrews

 

[Travis123]

I measured this once before but can't remember the dimensions. If you PM me as a reminder I'll get the measurements for you. Just XR30 or did you want the XR15 also?

Did you ever get those measurements? Curious to see if I can mount my Nicrew to a Radion bracket

 

[LordsReef]

The xr30 brackets are roughly 10 inches apart long ways and 5 inches apart on the short side. That’s roughly center to center.

 

[LordsReef]

The xr30 brackets are roughly 10 inches apart long ways and 5 inches apart on the short side. That’s roughly center to center.

That’s gen 5 to gen 6