Ocean revive t47 settings for 75g?

[jameslafo]

what height and intensity should I use for my 2 ocean revive t247 leds on a marine land 75 gallon with glass lids. I want to have lps and soft corals In it

 

[Ron Reefman]

Set the fixtures just high enough so the light covers the bottom of the tank.

I used to run mine at 80-90% blue and 30-40% white. Blues for 10 hours and whites for 6 at midday.

Hope that helps?

 

[Tuffyyyyy]

I used to have that light over my frag tank and it had some serious hot spots. I borrowed a PAR meter and found that 20" above the water finally had it spread out enough. That said, I was using a single one to cover a 36" tank, and you're using two for (I think) a 48" tank so I don't think you need to worry about going that high.

I always had blue at 100%, and then whites at like 20%-30%. This video might be a good reference for your tank:

 

[jameslafo]

Set the fixtures just high enough so the light covers the bottom of the tank.

I used to run mine at 80-90% blue and 30-40% white. Blues for 10 hours and whites for 6 at midday.

Hope that helps?

Awesome thank you so much I will try it out

 

[jameslafo]

I used to have that light over my frag tank and it had some serious hot spots. I borrowed a PAR meter and found that 20" above the water finally had it spread out enough. That said, I was using a single one to cover a 36" tank, and you're using two for (I think) a 48" tank so I don't think you need to worry about going that high.

I always had blue at 100%, and then whites at like 20%-30%. This video might be a good reference for your tank:

Thank you! I’m definitely going to use this to help!!