Osmolator 3 sensor flashing white.

Normally this will mean the safety sensor was submerged when you powered it up so it cannot calibrate and will not start running until the water level is below the safety and it can calibrate. If the safety is out of water it should calibrate within 2 minutes.
 

TOP 10 Trending Threads

WHAT’S USUALLY THE FIRST CLUE THAT SOMETHING IS OFF IN YOUR REEF?

  • A fish’s behavior or appetite changes

    Votes: 13 16.3%
  • A coral looks different or stops opening normally

    Votes: 49 61.3%
  • Water clarity or surface appearance changes

    Votes: 12 15.0%
  • Equipment sounds or flow seem different

    Votes: 9 11.3%
  • A test result catches my attention

    Votes: 17 21.3%
  • Algae or other growth starts changing

    Votes: 16 20.0%
  • I usually notice when the problem is already obvious

    Votes: 4 5.0%
  • It depends on what’s going on

    Votes: 16 20.0%
  • Other (Post in the comments)

    Votes: 1 1.3%
Back
Top
Home
Post thread…
Market
What's new