I been setting up my Maxi Master and a Maxi Slave.
I am running GCC 1.1.1.1 and I have the latest 1.28 firmware on the master.
When the Maxi Master is not connected I do not receive the PABCOM Error.
If I set the unit to be a Slave, connect it, and powerdown the unit for any reason I get a PABCOM Error.
As soon I reboot the master it goes away, just wondering if anyone else as seen this or should I be worried about it?
I have it off a PowerBar, I even moved it to right off the P4 same error.
I am running GCC 1.1.1.1 and I have the latest 1.28 firmware on the master.
When the Maxi Master is not connected I do not receive the PABCOM Error.
If I set the unit to be a Slave, connect it, and powerdown the unit for any reason I get a PABCOM Error.
As soon I reboot the master it goes away, just wondering if anyone else as seen this or should I be worried about it?
I have it off a PowerBar, I even moved it to right off the P4 same error.