Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
Trying to remove the bulkhead nut but it quite literally will not budge and it’s just starting to destroy the plastic nut, plus it’s getting so frustratingyes this drain over flow, clean glass at bulk ,and washer ,and bottom bulk ,and reinstall wet. hand tight ,lil snug.
hint you can do this from below with finger tip,careful of sharp edge..
try spraying with tank water or rodi, put cloth under pliers to hold threaded body ,just to hold to break free,careful not to crush threads ,only holding till nut breaks free.Trying to remove the bulkhead nut but it quite literally will not budge and it’s just starting to destroy the plastic nut, plus it’s getting so frustrating
Bout ready to bust out a hacksaw lol I have it halfway and it got stuck again and it’s just so hard to turnget it???
After almost 3 hours I’ve officially given up on trying to save the bulkhead, going to cut it off with a dremel and order a new one lol. Never thought a simple seal problem would end up with me replumbing the whole thingWhen I had similar problem , I removed bulkhead, cleaned up and used silicone on both sides of rubber seal, that way did not have to replace the seal or use too much force to tighten. Just my 2 cents
Those screw of clockwisTrying to remove the bulkhead nut but it quite literally will not budge and it’s just starting to destroy the plastic nut, plus it’s getting so frustrating