Plumbing size question....

xxxtremewv

Community Member
View Badges
Joined
Feb 17, 2018
Messages
84
Reaction score
61
What state or country do you live in
Illinois
Rating - 0%
0   0   0
hey guys, so recently i bought a 150 sca tank drilled for a synergy shadow, and was a little hesitant on sizing for plumbing sonfigured id ask this and get some suggestions before i went on. I ought a trigger emerald 39 sump which has 1” drain inputs. The lines coming out of the overflow are 1 1/2. Aiming for around 700 or 800 tops flow and the returns are 3/4. Will I be fine to do the drains to sump at 1” right off the overflow, or should i drill the sump inputs and make them 1 1/4 or 1 1/2? Would be a lot cheaper to run them all 1”, but will increase that if i need to. Just dont know a lot about plumbing capacities and this will be my first bean animal. Any thoughts?
 
Shouldn't be a problem reducing right at the overflow box, especially with the flow rates your aiming for which are well under a 1" siphons capacity.:)
 
With a full siphon you can get a lot more flow than you're desiring with 1" lines. I have 1" lines and about 1400 gph with a Bean Animal and my gate valve is cranked down a bunch.
 
Good deal! Thank you guys, was just wanting to make sure before insoent any more money
 

TOP 10 Trending Threads

WHAT DO YOU ALWAYS RUN OUT OF AT THE WORST TIME?

  • Salt mix

    Votes: 17 17.7%
  • Fish or coral food

    Votes: 5 5.2%
  • Test kits or reagents

    Votes: 10 10.4%
  • Filter media or replacement fleece

    Votes: 5 5.2%
  • RO/DI filters or supplies

    Votes: 15 15.6%
  • Fragging and repair supplies, like glue or epoxy

    Votes: 12 12.5%
  • I keep a backup of everything

    Votes: 25 26.0%
  • Other (Post in the comments)

    Votes: 7 7.3%
Back
Top
Home
Post thread…
Market
What's new