Power head Recommendation

  • Thread starter Thread starter Frogs62
  • Start date Start date
  • Tagged users Tagged users None

Frogs62

Community Member
View Badges
Joined
Feb 23, 2016
Messages
95
Reaction score
21
Location
Sugarland
What state or country do you live in
Texas
Rating - 0%
0   0   0
Looking for opinions/recommendations on a IN WATER (must go over flow box) power head keeping the following in mind. I have a 1000G (12ft) tank with 3/4 inch glass and I plan on adding a few high end BTA's so the ability to "cover" the power head in very important

Thank you
 
I'd be looking at a Tunze stream 6305
 
Are there nem protectors available for Tunze's?
 
Looking for opinions/recommendations on a IN WATER (must go over flow box) power head keeping the following in mind. I have a 1000G (12ft) tank with 3/4 inch glass and I plan on adding a few high end BTA's so the ability to "cover" the power head in very important

Thank you

Can you post a picture of the tank and where you want the powerhead to go? I'm not quite sure what you mean by over the overflow. Does it have to mount to the overflow box? Or does the cord have to come up over the box?

I'm thinking a closed loop style pump or a tunez is your best bet.
 
The magnate must go inside the overflow water box.. thus wet. Tunze's will work but I wanted to see if there any good alternatives as I have not seen any nem protectors for Tunze's
 
The magnate must go inside the overflow water box.. thus wet. Tunze's will work but I wanted to see if there any good alternatives as I have not seen any nem protectors for Tunze's
Ok that makes sense.

If you're just adding some flow take a look at the Nero 5 from AI. The magnet says for 1/2" but you can always get another one to hold it in place. If you have any farm supply stores near you, you can get rubber coated "cow magnets". They would probably hold through 1" glass. They're made to go in cow stomachs, if they can hold up to stomach acid they'll more than likely hold up to salt water.

Or adding a closed loop pump that runs up and over the back could work. You wouldn't have to worry about a guard for nems then.
 
I have my power heads in the overflow too! I use Jebao ow-50. They are powerful. I don’t know if it will come with a nem protector, but I’m sure you can DIY one easily.
 
I like the profile of the Nero 5 but worried about the glass thickness. Does anyone have any experience using one on 3/4-1 inch glass.?
 
I’m trying to decide between MP40 and Octo Pulse 4 for a similar situation but only 120G. That said the only powerhead that seems to have a readily available after market nem guard is the MP40. But the OctoPulse4 is really attractive for many other reasons.
 

TOP 10 Trending Threads

WHAT DO YOU ALWAYS RUN OUT OF AT THE WORST TIME?

  • Salt mix

    Votes: 17 18.5%
  • Fish or coral food

    Votes: 5 5.4%
  • Test kits or reagents

    Votes: 10 10.9%
  • Filter media or replacement fleece

    Votes: 5 5.4%
  • RO/DI filters or supplies

    Votes: 14 15.2%
  • Fragging and repair supplies, like glue or epoxy

    Votes: 10 10.9%
  • I keep a backup of everything

    Votes: 24 26.1%
  • Other (Post in the comments)

    Votes: 7 7.6%
Back
Top
Home
Post thread…
Market
What's new