PPBlimpy's S1000 downsize / upgrade

[Gumbies R Us]

Next will be modifying the overflows I made for the extension sump. I have them running the water level as high as possible and that will not work with the filter roller.
When I originally made them I did not make them adjustable. They do their job though and I have no more build up on the surface so keeping them in place is important.

Do you have an idea on how you are going to modify the overflows?

 

[PPBlimpy]

Do you have an idea on how you are going to modify the overflows?

Guess I should have gone more into detail. The overflows I am refering to were 3d printed by me and go on the in flow and out flow of the extension sump. They are a tube at the bottom of the sump that passes thru a wall. It leave zero surface skimming and very, very little surface agitations.

 

[Gumbies R Us]

Guess I should have gone more into detail. The overflows I am refering to were 3d printed by me and go on the in flow and out flow of the extension sump. They are a tube at the bottom of the sump that passes thru a wall. It leave zero surface skimming and very, very little surface agitations.

Oh sweet. Those are going to be awesome to have!

 

[PPBlimpy]

Oh sweet. Those are going to be awesome to have!

Just edited and loaded photos on the previous post of the overflows. Had to go on my phone and find pictures

 

[Gumbies R Us]

Just edited and loaded photos on the previous post of the overflows. Had to go on my phone and find pictures

I'm assuming it was done in PETG?

 

[PPBlimpy]

Yep. Everything is in Petg. I base it by the case. 10rolls at a time

 

[PPBlimpy]

Little more progress on the roller. For the arms for the drive side done. Printing the cross braces now. Also got the paper guide done.
Needed to redesign the arms that hold the fresh roll. Original design interfered with plumbing.

Need to order up the nylon hardware, drive motor and a roll of fleece soon.

Have probably another 60 hours worth of printing still.

Photos are just a quick mock up

 

[PPBlimpy]

i have started using the 3D printers at my shop finally. usually only the engineers have access to them. we have a bambu lab p1s and a p2s.

I am realizing I really need to upgrade my printer to something a bit more modern. my cr-10 is at least 12 years old. its been faithful, most issues were operator error but dang these new ones are nice.

not sure i would go bambu but maybe a creality or elgoo. not sure yet.

 

[PPBlimpy]

It has taken me a long time but I have finally got every pieces 3d printed for my roller mat. I am sure I will need to redesigned and change some things once it’s running..

Now to order the drive motor- 3rpm 110v ,
Nylon hardware to secure everything and - roll of filter paper!

Now let’s see if I can find all my notes with part #s to order