joe-ejs
Active Member
Hello. I am working my way through my first QT process. Thus far I have:
- completed 30 day Copper Treatment using CopperSafe at 2.0 and salinity was around 1.018.
- completed 1st 7day treatment of Prazi this morning. I move salinity up to 1.021 prior to starting Prazi.
I am going to do 2nd 7 day dose of Prazi later today. Getting ready to do 25% water change first prior to adding Prazi later today.
Question is should I raise salinity again slightly to get closer to Display Tank level or keep it where it is? I was thinking of moving salinity up to 1.023 with water change and was wondering if this is a good idea or leave it as is and just deal with the salinity difference between the QT and DT tanks when I acclimate the fish on their way to the DT .
Little late to ask but still learning...and advice is appreciated.
Thanks
- completed 30 day Copper Treatment using CopperSafe at 2.0 and salinity was around 1.018.
- completed 1st 7day treatment of Prazi this morning. I move salinity up to 1.021 prior to starting Prazi.
I am going to do 2nd 7 day dose of Prazi later today. Getting ready to do 25% water change first prior to adding Prazi later today.
Question is should I raise salinity again slightly to get closer to Display Tank level or keep it where it is? I was thinking of moving salinity up to 1.023 with water change and was wondering if this is a good idea or leave it as is and just deal with the salinity difference between the QT and DT tanks when I acclimate the fish on their way to the DT .
Little late to ask but still learning...and advice is appreciated.
Thanks
