PVC Pipe in Aquarium

piranhaman00

5000 Club Member
View Badges
Joined
Jun 24, 2019
Messages
5,096
Reaction score
4,888
Rating - 0%
0   0   0
Hello, I see a lot of people using pvc for holding up live rock, hides for QT tank ect. I bought some random pvc piping from Menards yesterday for the QT tank and now I am questioning it, would like some input.

Some of the piping had stickers on them as the barcode. When I peeled the sticker off it left a nice residue that is very difficult to remove completely. A few different pieces had the barcode printed on it seems. I was able to rub my finger on the barcode and pick up some of the black ink. These both cannot be suited for any aquarium correct? Where do people buy there pvc that is label free? Am I overthinking? Thanks!
 
What I do is take rubbing alcohol and remove bar code and glue residue. Never had an issue with it.
 
Hello, I see a lot of people using pvc for holding up live rock, hides for QT tank ect. I bought some random pvc piping from Menards yesterday for the QT tank and now I am questioning it, would like some input.

Some of the piping had stickers on them as the barcode. When I peeled the sticker off it left a nice residue that is very difficult to remove completely. A few different pieces had the barcode printed on it seems. I was able to rub my finger on the barcode and pick up some of the black ink. These both cannot be suited for any aquarium correct? Where do people buy there pvc that is label free? Am I overthinking? Thanks!


Hey piranhaman00 !!!!! I switched all my PVC overt to black colored PVC which is usually furniture grade and without any printed bar-codes. Prior to that, I've used some reg PVC that had the bar-code directly printed on the PVC in black ink and also as a sticker, as you were describing. I found that soaking them in a vinegar bath takes care of both or removing with rubbing alcohol and/or adhesive remover first and then the vinegar. Hope that helps.

:cool::cool::cool:
 
What I do is take rubbing alcohol and remove bar code and glue residue. Never had an issue with it.

I was thinking of trying this, thanks!


Hey piranhaman00 !!!!! I switched all my PVC overt to black colored PVC which is usually furniture grade and without any printed bar-codes. Prior to that, I've used some reg PVC that had the bar-code directly printed on the PVC in black ink and also as a sticker, as you were describing. I found that soaking them in a vinegar bath takes care of both or removing with rubbing alcohol and/or adhesive remover first and then the vinegar. Hope that helps.

:cool::cool::cool:


Awesome! I have them soaking in vinegar for over 24hours now, I will hit them with rubbing alcohol as well, thanks a lot!
 

TOP 10 Trending Threads

WHAT DO YOU ALWAYS RUN OUT OF AT THE WORST TIME?

  • Salt mix

    Votes: 17 18.9%
  • Fish or coral food

    Votes: 5 5.6%
  • Test kits or reagents

    Votes: 9 10.0%
  • Filter media or replacement fleece

    Votes: 5 5.6%
  • RO/DI filters or supplies

    Votes: 14 15.6%
  • Fragging and repair supplies, like glue or epoxy

    Votes: 10 11.1%
  • I keep a backup of everything

    Votes: 23 25.6%
  • Other (Post in the comments)

    Votes: 7 7.8%
Back
Top
Home
Post thread…
Market
What's new