Quick question about the pwm v2. My led driver is powered by a meanwell brick, on the driver the dimming channels share the same ground. So if I have this right, Chan 1, Chan 2, go to the #4, #5 terminal, ground to #6. How many amps do I need for the power supply? I have a 12v 1a.
Pwm breakout box power supply
- Thread starter topjimmy
- Start date
- Tagged users None
Users Who Are Viewing This Thread (Total: 1, Members: 0, Guests: 1)
vangvace
Well-Known Member
You have a 5 hour ramp up. Assuming you want the same ramp down your schedule would be:
7am 0%
12pm 100%
4pm 100%
9pm 0%
The way you had it, the lights would peak at 12pm and start ramping down immediately. My suggestion keeps the lights at a certain percentage for a few hours before ramping down. Regardless of the actual times, you will want to use 4 time stamps.
OP
OP
- Joined
- May 26, 2016
- Messages
- 676
- Reaction score
- 569
Ok I must be doing something wrong. If I have only two channels, do I only use one Lport? If that's the case then what 0-10v interfaces do I assign to the illumination channels?
The lights sort of work they don't dim to zero and it seems like both channels are sort of combined.
The lights sort of work they don't dim to zero and it seems like both channels are sort of combined.
vangvace
Well-Known Member
PWM-OUT Pins 4, 5, and 6 go to the Left (L1/L2) yellow port on the PWMv2. If you aren't using the L1/L2 on the back of the Profilux, I would plug into that port and configure Illumination channels 1 and 2 along with 1-10V interface channels 1 and 2 respectively for the percentages.
Here is a link to the manual which might help too.
Here is a link to the manual which might help too.
Similar threads
