Redsea Filter floss tray??

[Whisnantrider]

has anyone or is anyone interested in trying to produce a filter floss tray for the Redsea synod to replace the filter sock tray? Something like what FijiCube does in their sumps? I will post pictures below for examples.

Replacing this:

With something like this:

 

[Sabellafella]

Brilliant. Following

 

[slogan315]

What are the rough dimensions you’re thinking? My printer is about 9x9 at the base. Would it be bigger than that?

 

[Whisnantrider]

What are the rough dimensions you’re thinking? My printer is about 9x9 at the base. Would it be bigger than that?

Rough measurements would be 8.75” long 4.5” wide 3” deep. if It was a slide in type of tray like the sock holder is. I think the biggest issue is going to be figuring out the shape needed because of the circular end on the tray holder.

 

[ashburn2k]

anyone tackled this yet ?

 

[jon2norris]

I found this for the 350, I’ll try and remix it into a tray and extend it when I get off work, I’m not the best with tinkercad but shouldn’t be too hard with the hard part already done https://www.thingiverse.com/thing:5566372

 

[Whisnantrider]

anyone tackled this yet ?

Not yet, I have reached out to a few companies to see if they would be interested as well but nothing as of yet.

I found this for the 350, I’ll try and remix it into a tray and extend it when I get off work, I’m not the best with tinkercad but shouldn’t be too hard with the hard part already done https://www.thingiverse.com/thing:5566372

That looks like a great starting point.

 

[slogan315]

Finally got my printer setup again. Is anyone actively working this? If not I’d like to start working on it.

 

[Whisnantrider]

Finally got my printer setup again. Is anyone actively working this? If not I’d like to start working on it.

No one to my knowledge

 

[Whisnantrider]

HUGE THANKS to slogan315
This project is coming together nicely!

Finally got my printer setup again. Is anyone actively working this? If not I’d like to start working on it.