valencianaquarium
New Member
Hello everybody! I am starting my smart aquarium project with raspberry pi zero W and Reef-pi so I apologize first of all for the questions because I am very new.
I bought this water level sensor (the same one that appears in Ranjib Dey's tutorial):
www.cqrobot.com
I have connected the OUT to GPIO17 and checked with the raspberry pi command window that it detects it and works fine:
But how do I detect it now with Reef-pi? In all the tutorials I have seen it was connected directly from the connectors section by assigning the pin but now I see in the last 6.0 version of Reef-pi that I have to assign it to a driver:
But I test with some drivers but I don't know what driver select:
Could you help me please?
Thank you very much! I have just discovered this great community and I think it can enrich me a lot!
I bought this water level sensor (the same one that appears in Ranjib Dey's tutorial):
Contact Water / Liquid Level Sensor for Raspberry Pi and Arduino.
CQRobot Contact Water/Liquid Level Sensor, This is a photoelectric water liquid level sensor that is operates using optical principles. The advantages of this photoelectric water liquid level sensor are good sensitivity and no need for mechanical parts - meaning less calibration! The corrosion resis
www.cqrobot.com
I have connected the OUT to GPIO17 and checked with the raspberry pi command window that it detects it and works fine:
But how do I detect it now with Reef-pi? In all the tutorials I have seen it was connected directly from the connectors section by assigning the pin but now I see in the last 6.0 version of Reef-pi that I have to assign it to a driver:
But I test with some drivers but I don't know what driver select:
Could you help me please?
Thank you very much! I have just discovered this great community and I think it can enrich me a lot!
Last edited:
