Remove EB8 and adding eb832 to apex

[Dolelo96]

I have a new eb832 and I want to delete my eb8 and start fresh. Is there anything specific I should do to make sure I don’t mess this up?

 

[ColdOceanReef]

Plug in the new EB832. Apex should recognizes it. At that time you should see 2 modules. Do so, If you need to duplicate the programs from the older EB8. Otherwise, just Delete the eb8 module once you confirmed your new eb832 is working properly.

 

[Bob Escher]

Just add it and pull the EB8

 

[radiata]

I have a new eb832 and I want to delete my eb8 and start fresh. Is there anything specific I should do to make sure I don’t mess this up?

You didn't mention the model of your Apex controller. EB832s don't work with earlier Apexes.

 

[Dolelo96]

I’m sorry, I was in the middle of trying to put together my controller board. I have the 2016 controller.

 

[DarthSimon]

Yea just plug into AquaBus, all the Outlets will appear. Drag them down and program. Copy and paste code as needed. Then Remove EB8...

 

[Dolelo96]

Thank you so much!