Remove Triton Sump Probe Holder

[Brandon Rush]

Has anyone removed the Triton Sump probe holder? I am trying to fit a Nyos Torq Reactor in my Skimmer section, but the probe holder is preventing me from doing so. It looks like it's epoxied on there? Should I just tap at it with a hammer and chisel?

 

[DLHDesign]

The sump is assembled using acrylic cement - not the same as epoxy. It's basically one piece of acrylic now (or near enough that the difference doesn't matter). You would likely have to cut it off (with a Dremel or the like) if you wanted to avoid the chance of cracking the sump wall.

 

[Brandon Rush]

The sump is assembled using acrylic cement - not the same as epoxy. It's basically one piece of acrylic now (or near enough that the difference doesn't matter). You would likely have to cut it off (with a Dremel or the like) if you wanted to avoid the chance of cracking the sump wall.

Thanks for the info