Removing weir teeth

[Charley75]

I have a new Glass Cages 150gallon. I want to remove some of the teeth in the weir for the return lines. It didn’t come with a spot for the return. What is the best way to cut some out?

 

[Science/G]

It's acrylic correct?!! A Dremel bit for cutting will do the job

 

[areefer01]

Try your best to go slow and make it straight. Not a huge deal if not.

 

[Charley75]

Have no clue what it’s made of. The tank is glass.

 

[areefer01]

Have no clue what it’s made of. The tank is glass.

Reach out to glass cages. They will respond if you are not sure. You don't want to damage it.

 

[Charley75]

I did already….guess I’ll wait for a response.

 

[Reign1]

Its acrylic ..I have a GC and just used a jig saw with plastic cutting bit to notch this out. As other poster stated you can also use a dremel.

 

[Charley75]

Joe responded this morning. Acrylic just like Reign1 stated above. Joe’s service is always awesome.

 

[F i s h y]

i used a dremel to cut the teeth on my glass cages weir.

 

[Charley75]

Any specific but for the dremel?

 

[F i s h y]

Any specific but for the dremel?

I just used the same diamond cutting wheel i use when fragging coral.