Return plumbing

Clarkjw2002

Active Member
View Badges
Joined
Jul 13, 2021
Messages
271
Reaction score
301
Location
Bedford, PA
What state or country do you live in
Pennsylvania
Rating - 100%
1   0   0
I am currently planning out the return lines for my 400 gal build. Main tank is 315 gal and the refugium is 125 gal. These tanks will be fed off the same pump. The return pump outlet is 1.25" and I plan to reduce the two return lines to 1" each.

I plan to split the line off the pump with a wye. My question is: should I use a 1.25" wye and reduce both lines to 1" immediately after or is reducing the return line to 1" just before the wye and using a 1"wye sufficient? The latter was my original plan but I am trying to minimize head loss as much as possible. All turns in the return lines will be with 45s. Thanks.
 
I’ll bump your question and give a couple of thoughts.
On my 180 I used 1 return pump and a T. I intended to plumb the T into the center of my tank return line for equal pressure but just because of configuration or whatever I didn’t. I can tell a little more flow exits the shorter line. Also on my tank an added a ball valve so that I could do maintenance and or equalize the flow between the two.

I know I didn’t answer your question but I personally wouldn’t think it would matter when you decrease the size.
IMG_3311.jpeg
IMG_3315.jpeg
 

TOP 10 Trending Threads

WHAT DO YOU ALWAYS RUN OUT OF AT THE WORST TIME?

  • Salt mix

    Votes: 17 18.5%
  • Fish or coral food

    Votes: 5 5.4%
  • Test kits or reagents

    Votes: 10 10.9%
  • Filter media or replacement fleece

    Votes: 5 5.4%
  • RO/DI filters or supplies

    Votes: 14 15.2%
  • Fragging and repair supplies, like glue or epoxy

    Votes: 10 10.9%
  • I keep a backup of everything

    Votes: 24 26.1%
  • Other (Post in the comments)

    Votes: 7 7.6%
Back
Top
Home
Post thread…
Market
What's new