RFS 39 Heater probe placement?

SaltAndSky

New Member
View Badges
Joined
Jul 30, 2026
Messages
2
Reaction score
0
What state or country do you live in
California
Rating - 0%
0   0   0
Where are you guys putting the heater probes for this sump? I only see wire slots in the return chamber and the skimmer chamber. Thanks!
 
Where are you guys putting the heater probes for this sump? I only see wire slots in the return chamber and the skimmer chamber. Thanks!
@SaltAndSky
I see this is your first post. Welcome.

When you say heater probes, do you mean the sensor or the heating element?

This is what AI says about your question.

where does heater go?
The heater goes into the dedicated vertical heater compartment located right after the filter cup/sock chamber.

Here is exactly how the water flows through the sump so you can find it:

  1. Drain Chamber: Water enters through the bulkheads into the filter media cups.
  2. Heater Slot: The water immediately spills over into a narrow, vertical slot designed specifically to hold titanium or glass heater elements upright.
  3. Skimmer Chamber: Water then flows into the large open area where your protein skimmer sits.
 
Yeah, I was asking about the sensor. I have the heaters in the proper chamber, which is right after the overflow. So there is no way that I can see to get the sensors before the heaters
 
Yeah, I was asking about the sensor. I have the heaters in the proper chamber, which is right after the overflow. So there is no way that I can see to get the sensors before the heaters
Consider putting sensor in the display. However, if you do this, in a sceanario where flow is interrupted if a pump fails, you should have a second sensor to turn heater off.

Here in Texas, I don’t use heater in any of my reef tanks.
 
Last edited:

TOP 10 Trending Threads

WHAT DO YOU ALWAYS RUN OUT OF AT THE WORST TIME?

  • Salt mix

    Votes: 17 17.7%
  • Fish or coral food

    Votes: 5 5.2%
  • Test kits or reagents

    Votes: 10 10.4%
  • Filter media or replacement fleece

    Votes: 5 5.2%
  • RO/DI filters or supplies

    Votes: 15 15.6%
  • Fragging and repair supplies, like glue or epoxy

    Votes: 12 12.5%
  • I keep a backup of everything

    Votes: 25 26.0%
  • Other (Post in the comments)

    Votes: 7 7.3%
Back
Top
Home
Post thread…
Market
What's new