RODI System Outdoors

Archibald J McLauchlin

Active Member
View Badges
Joined
May 31, 2019
Messages
101
Reaction score
115
Location
St. Petersburg
Rating - 0%
0   0   0
I got my BRS 6 Stage RODI system and I have not yet inatalled it. Right now it looks like the water station I am going to setup is just going to be in the rear corner of my backyard. Are there any cons to setting up the system out in the elements or anything specific to an RODI I should take note of before operating this way? Thank you in advance.
 

Camaro Show Corals

7500 Club Member
View Badges
Joined
Mar 19, 2018
Messages
8,767
Reaction score
6,588
Location
Wheeling, WV
Rating - 73.7%
13   5   1
Well not many people install rodi outside but I see you are in Sunny Florida. Is there a reason you want it outside? The only thing I can see is the heat and sun taking a toll on the plastic. As for the filtration it should last the same as it would be inside with the only factor being your incoming water quality.
 

Tastee

Valuable Member
View Badges
Joined
Oct 19, 2018
Messages
1,124
Reaction score
872
Location
Sydney, Australia
Rating - 0%
0   0   0
Mine is outside but in a custom built cabinet so that it is protected from sun and rain. I would recommend at least a small hood be built to mount over it for protection from UV.
 

AZMSGT

2500 Club Member
View Badges
Joined
May 6, 2019
Messages
3,986
Reaction score
6,862
Rating - 0%
0   0   0
RO membranes are degraded by heat. If the sun beats down on it could have a negative effect on how long the membrane lasts. Also none of the equipment is UV protected. All these issues can be eliminated buy covering or installing indoors.
 

cgdcinc

Active Member
View Badges
Joined
Dec 17, 2016
Messages
383
Reaction score
670
Rating - 0%
0   0   0
Mine is out under a covered porch in Florida. No direct sunlight on it. Works great. I would keep it out of the sun.
 

Blue Ring Octopus

2500 Club Member
View Badges
Joined
Dec 30, 2016
Messages
3,708
Reaction score
1,561
Rating - 0%
0   0   0
I have mine in a Brute trash can with a lid on it, never in the sun. It is cooler outside than in the garage.
 

Eggs

Well-Known Member
View Badges
Joined
Aug 15, 2009
Messages
905
Reaction score
517
Location
South Florida
Rating - 0%
0   0   0
Following along, facing the same issue setting up a 300g in Florida. Have a few ideas, we can figure this out.
Person that I bought the tank off of had his RODI outside and said he had no issues with the water, unit or membrane.
 
OP
OP
Archibald J McLauchlin

Archibald J McLauchlin

Active Member
View Badges
Joined
May 31, 2019
Messages
101
Reaction score
115
Location
St. Petersburg
Rating - 0%
0   0   0
I am looking at putting it outside because it seems to be the best place for most requirements that will be needed. UV is my main concern, fairly decent tree canopy but out in the elements I suspect life of most membranes and such will be shorter. I have 2 Brute 55 gallon cans for storage. This is the area I am looking at converting for my mixing/storage and water processing.
20190704_143330.jpg 20190704_143422.jpg
 

Dr. Reef

www.drreefsquarantinedfish.com
View Badges
Joined
Jan 22, 2013
Messages
4,290
Reaction score
7,510
Location
Tulsa, OK
Rating - 100%
4   0   0
Heat and cold both will have effect on the unit like mentioned above.
If temps are freezing then water will expand inside the chambers and some may burst as well.
If you were to install is outside, I would cover it or place it inside a cabinet which is insulated to protect it from elements.
 

Gareth elliott

Read, Tinker, Fail, Learn
View Badges
Joined
May 7, 2017
Messages
5,470
Reaction score
6,903
Location
NJ
Rating - 0%
0   0   0
You could build something to cover it. Paint it white and use plain unpainted aluminum flashing for the “roofing” material. Some kind of vents could be as simple as a gap created at the top and bottom of the construction.
 

JoshH

Tank Status: Wet...ish, growing things....
View Badges
Joined
Dec 3, 2016
Messages
10,004
Reaction score
32,592
Location
Humble
Rating - 0%
0   0   0
Any chance you could purchase a Shed of some kind?It would look nice and contain/protect all of your mixing containers and RODI setup. If you get a really good quality plastic shed you would never have to worry about corrosion either.
 

dowsetts101

Active Member
View Badges
Joined
Apr 21, 2017
Messages
206
Reaction score
257
Location
Melbourne, Australia
Rating - 0%
0   0   0
I’m in a similar situation...have done my water change station outside. Have my chiller out there as well, which I run in summer.

Plenty of ventilation in the timber cladding, and a lightweight roof to keep the weather off and shade the equipment.

I’ve only had it up for 12 months but is working nicely so far.


05d8e53dcf6ac266bb5cc6dac63a3e24.jpg



91e74ad5681e4023b92a2dc5d3ee3f5e.jpg
 

Eggs

Well-Known Member
View Badges
Joined
Aug 15, 2009
Messages
905
Reaction score
517
Location
South Florida
Rating - 0%
0   0   0
I’m in a similar situation...have done my water change station outside. Have my chiller out there as well, which I run in summer.

Plenty of ventilation in the timber cladding, and a lightweight roof to keep the weather off and shade the equipment.

I’ve only had it up for 12 months but is working nicely so far.


05d8e53dcf6ac266bb5cc6dac63a3e24.jpg



91e74ad5681e4023b92a2dc5d3ee3f5e.jpg

I remember reading your thread when I was searching for outdoor water stations, I think I even saved your pictures that you posted for some ideas.
 

TOP 10 Trending Threads

WHAT AMOUNT OF LIVE ROCK AND SAND SHOULD BE PRIORITIZED FOR OPTIMAL BIODIVERSITY/FILTRATION?

  • 100% live rock + bagged sand

    Votes: 37 27.4%
  • 100% dry rock + 100% live sand

    Votes: 46 34.1%
  • 50/50 live/dry rock, 50/50 live/bagged sand

    Votes: 30 22.2%
  • 75% live rock, 25% live sand

    Votes: 12 8.9%
  • 25% live rock, 75% live sand

    Votes: 10 7.4%
Back
Top