Salinity went up.

Notsolostfish

2500 Club Member
View Badges
Joined
Jan 21, 2014
Messages
2,961
Reaction score
800
Rating - 0%
0   0   0
Iv been running awc for sometime now through neptune 1% a day on a 150G my watef always been stable salinity at 1.026 i confirm with hydrometer, and milwaukee as well. Today i tested and its 1.027. I always tested 1.026 and while 1.027 is no big deal dont want it to go up.

I tested the mixing bin and it was at 1.027 seems like it went up. From evaporation. Would that be the reason my salinity went up?
 
Iv been running awc for sometime now through neptune 1% a day on a 150G my watef always been stable salinity at 1.026 i confirm with hydrometer, and milwaukee as well. Today i tested and its 1.027. I always tested 1.026 and while 1.027 is no big deal dont want it to go up.

I tested the mixing bin and it was at 1.027 seems like it went up. From evaporation. Would that be the reason my salinity went up
assume you're using roti pure water for replacement
 
When doing daily AWC, the two ways to adjust for possible pump mismatch or anything else that caused salinity to get off target is to adjust the new water salinity to slowly compensate, or adjust the times of the different pumps separately. I adjust salinity and keep
Both pumps on the same timer.
 
When doing daily AWC, the two ways to adjust for possible pump mismatch or anything else that caused salinity to get off target is to adjust the new water salinity to slowly compensate, or adjust the times of the different pumps separately.
Do u think the 1.027 in the bin is the reason my salinity went up in the display?
 
When doing daily AWC, the two ways to adjust for possible pump mismatch or anything else that caused salinity to get off target is to adjust the new water salinity to slowly compensate, or adjust the times of the different pumps separately. I adjust salinity and keep
Both pumps on the same timer.
I calibrated my neptune dos pumps today and they are on the dot. Idk why my salinity is higher not sure whats going on :(
 

WHICH PART OF YOUR SETUP IS HARDEST TO REACH OR REMOVE FOR ROUTINE MAINTENANCE?

  • Glass behind or beside the tank

    Votes: 9 25.0%
  • Powerheads or wavemakers

    Votes: 3 8.3%
  • Sump or rear filtration chambers

    Votes: 5 13.9%
  • Skimmer or other filtration equipment

    Votes: 2 5.6%
  • Overflow or plumbing

    Votes: 8 22.2%
  • Lights or lids

    Votes: 0 0.0%
  • Mine is pretty easy to access!

    Votes: 8 22.2%
  • Other—tell us what I missed

    Votes: 1 2.8%
Back
Top
Home
Post thread…
Market
What's new