Setting up chiller

  • Thread starter Thread starter Bent17
  • Start date Start date
  • Tagged users Tagged users None

Bent17

Well-Known Member
View Badges
Joined
Mar 19, 2022
Messages
544
Reaction score
85
Location
Space
What state or country do you live in
Kentucky
Rating - 0%
0   0   0
Hi all - I am about to set up my Teco 500 Chiller and I'm not sure how I should configure it.

I have my temp set to 25c with the Reef Factory Thermo Controller.

In order to retain the constant 25c how should the temp of the chiller be set to?
 
I have my thermo control set to 25c so my heater kicks in at 24.8 and fan at 25.2. My heaters thermostat is set higher to 25.5 but is controlled by the TC, so I’m guessing you’d set your chiller to 24.8 so when it kicks in it’ll cool the tank to the desired 25 and stop cooling.
 
Last edited:
Figure out the cycle of your controller. 1 degree? 2? This is where F might be better since it can be more granular if you do not have tenths of a degree.

Short cycling your chiller can be bad.

Then, put your desired temp in the middle. I use F, so if I want the thing at 77, I set the temp at 77 and have a 2 degree interval so the chiller comes on at 75.9 and goes off at 78.1. This lets the chiller run longer.. so I range from 76 to 78. I don't really need one anymore, but when I did it only probably came on once a day.
 
Last edited:
Mine comes on at 80F and off at 77.7 (just above where my heaters will turn on). It cycles about every four hours in warmer months.
 

TOP 10 Trending Threads

WHAT DO YOU ALWAYS RUN OUT OF AT THE WORST TIME?

  • Salt mix

    Votes: 17 18.9%
  • Fish or coral food

    Votes: 5 5.6%
  • Test kits or reagents

    Votes: 9 10.0%
  • Filter media or replacement fleece

    Votes: 5 5.6%
  • RO/DI filters or supplies

    Votes: 14 15.6%
  • Fragging and repair supplies, like glue or epoxy

    Votes: 10 11.1%
  • I keep a backup of everything

    Votes: 23 25.6%
  • Other (Post in the comments)

    Votes: 7 7.8%
Back
Top
Home
Post thread…
Market
What's new