shark - wound - parasite?

Could those be ammonia burns? Turns out the shark was shipped with ammonia levels already at .25 when bagged. Vendor said its fine for sharks to be in ammonia .25 to .35. I said it should be zero.

Ammonia is more damaging to the fish's gills. When you see water quality issues in sharks, it often shows as petechia - red spots.

Do you know what the ammonia was at the end of the shipment though? I agree 0.25 ppm isn't an issue for sharks short-term, but it could have been much higher by the end of the shipment if it took the typical 24 to 36 hours for shipping time.

Jay
 
Ammonia is more damaging to the fish's gills. When you see water quality issues in sharks, it often shows as petechia - red spots.

Do you know what the ammonia was at the end of the shipment though? I agree 0.25 ppm isn't an issue for sharks short-term, but it could have been much higher by the end of the shipment if it took the typical 24 to 36 hours for shipping time.

Jay
I didnt measure ammonia in the bag as I didn’t realize that could be the issue. All 3 sharks died within 2-3 days from this vendor with the same red spots
 
I didnt measure ammonia in the bag as I didn’t realize that could be the issue. All 3 sharks died within 2-3 days from this vendor with the same red spots
I just ordered from this vendor.. Something I should be concerned about?
 
I just ordered from this vendor.. Something I should be concerned about?
No worries from me. He replaced those that died. I have received smoothhounds after those and everything is good. I am getting another one tomorrow from him.
 
No worries from me. He replaced those that died. I have received smoothhounds after those and everything is good. I am getting another one tomorrow from him.
He’s supposed to ship mine midweek. Can I ask how you acclimated. He’s telling me to float and release. I usually drip acclimate but he’s saying it’s more important to get them out of the shipping water ASAP.

I intended to order 3 from him. But not much info on this vendor so I’m starting with a small order.
 
Last edited:
He’s supposed to ship mine midweek. Can I ask how you acclimated. He’s telling me to float and release. I usually drip acclimate but he’s saying it’s more important to get them out of the shipping water ASAP.

I intended to order 3 from him. But not much info on this vendor so I’m starting with a small order.
I float the sealed bag for 30 mins and then release directly into my pond. We did these because of the ammonia levels. I measured the ammonia immediately after opening the bag and it was off the chart. I added a couple new videos to my album link.
 
Last edited by a moderator:
I float the sealed bag for 30 mins and then release directly into my pond. We did these because of the ammonia levels. I measured the ammonia immediately after opening the bag and it was off the chart. I added a couple new videos to my album link.
The ammonia off the charts is concerning. Hopefully he sends direct flight. As I’m 2hrs away from Orlando international.
 
Last edited by a moderator:

TOP 10 Trending Threads

WHICH PART OF YOUR SETUP IS HARDEST TO REACH OR REMOVE FOR ROUTINE MAINTENANCE?

  • Glass behind or beside the tank

    Votes: 11 22.0%
  • Powerheads or wavemakers

    Votes: 4 8.0%
  • Sump or rear filtration chambers

    Votes: 7 14.0%
  • Skimmer or other filtration equipment

    Votes: 6 12.0%
  • Overflow or plumbing

    Votes: 10 20.0%
  • Lights or lids

    Votes: 0 0.0%
  • Mine is pretty easy to access!

    Votes: 11 22.0%
  • Other—tell us what I missed

    Votes: 1 2.0%
Back
Top
Home
Post thread…
Market
What's new