Show us your controller boards!

[DmitryB]

These are what I bought at BRS recommendation.

https://a.co/d/06az6n1m

It really does make it look nice and clean!

Ahhh ok good, not a hard-wire replacement! I was afraid it'd be that.

Are any of you using DC Buddy?

 

[Gumbies R Us]

Here is my two boards that are not in the stand. The first one is in the garage at my mixing station. I have replaced the pumps on the right since the photo with a Minnow, Blenny and Sole dosing pump controllers. otherwise it has not changed too much I have removed the Digital Aquatics modules since the photo also. The second photo is the one next to the tank. I have added a X3-S controller under the X10 on the left. I also have a WEv2, XP8, XS and X3 mounted in the stand. I also have a Launch and a XD that are on the work bench in the garage and have not been mounted yet.

I gotta ask, where did you get the hydros sign at?

 

[AlyciaMarie]

Did a DIY board for my 40b. Older pics before anything added, I don't have "automation" controllers on it, just temp, powerheads, and return pump. I do have a DIY feed button that uses a DIY delay on timer for the power heads (5 min) and return pump (10 min).

Looks awesome! You should do a write-up on it in the DIY forum!

 

[TDehler]

I made this from a wayfair cabinet. I flipped and cut one of the shelves to be a backplate to mount my equipment and added the power bar with switches to easily turn on/off specific equipment. This makes cable management so much easier because I can just stuff them in the back part of the cabinet behind the vertical panel.

 

[craftycamper]

Still in progress on the lower part, but this is what I have so far. I used Multiboard and 3d printed all of the mounts and the board they mount to. I need to design a better method to secure the board in place however.

 

[SteveMM62Reef]

Not a Controller Board but a Power Cabinet for my 12Vdc Lighting.

 

[DmitryB]

I made this from a wayfair cabinet. I flipped and cut one of the shelves to be a backplate to mount my equipment and added the power bar with switches to easily turn on/off specific equipment. This makes cable management so much easier because I can just stuff them in the back part of the cabinet behind the vertical panel.

Repurposing a cabinet is a great idea.

 

[ShakeyGizzard]

Looks awesome! You should do a write-up on it in the DIY forum!

I could, its in my build thread, pic's are easy to come by

 

[n2585722]

I gotta ask, where did you get the hydros sign at?

I got it from CoralVue so some dealers may also have them.