Skeleton or normal

Rocks reef

Rockin' the Reef
View Badges
Joined
Aug 14, 2017
Messages
11,365
Reaction score
66,273
Location
Michigan
Rating - 100%
4   0   0
I must have overlooked this, but you said you saw damage to the coral from the peppermint shrimp?
 

Red_Beard

I already did
View Badges
Joined
Feb 17, 2019
Messages
6,797
Reaction score
18,952
Location
Utah
Rating - 0%
0   0   0
That light should be capable of keeping that coral alive, as long as you have it turned up and the frogspawn isn't shaded or on the edge. you may need to move it up the rock a little higher when it starts to look better. When stuff gets damaged, like what looks like happened to the center, it can help to keep them in gentler flow and a little less intense lighting for a week or two. Where you aren't blasting it with light where it is, it should be ok as is for now. Has it started looking better or worse in the last few days? or stayed the same?
 

BitR0t

Community Member
View Badges
Joined
Mar 12, 2026
Messages
49
Reaction score
20
Location
USA
Rating - 0%
0   0   0
I agree with Gumbie on his recommendations. However, that frogspawn isn't going to make it. Was it like that when you purchased it from the LFS?
Also, two months is still a very new tank. The stability isn't there yet.
What kind of light do you have?
I am new to this hobby also, how can you tell it won’t make it? You are looking at the white skeletal structure and how it meets the flesh? I am thinking it should be white from frag disk till the flesh?
 
OP
OP
J

jerrye

New Member
View Badges
Joined
Mar 25, 2026
Messages
13
Reaction score
4
Location
redding
Rating - 0%
0   0   0
Update left it in there and got a acrylic lid and the coral is doing much better
20260329_193741_9170BE54-A4EC-4FB6-ACCC-539840AACD40.png
 
Last edited:

higher99

Active Member
View Badges
Joined
Dec 17, 2025
Messages
351
Reaction score
219
Location
New York
Rating - 100%
1   0   0
I have a 20 gallon aio innovated marine tank I have a wave maker I could move to get it more flow it is not controllable tho
I got a new hammer frag online and since they shipped it overnight, the polyps were pretty much fully open in the bag when it arrived.

Did your frag fully open at the LFS / before you place it into the tank?

I suspect that it has a shock from either accimation or is just getting used to the tank parameters.

Also if you got any hermit crabs, they love bothering corals, espically new ones.
 
OP
OP
J

jerrye

New Member
View Badges
Joined
Mar 25, 2026
Messages
13
Reaction score
4
Location
redding
Rating - 0%
0   0   0
I have a 20 gallon aio innovated marine tank I have a wave maker I could move to get it more flow it is not controllable tho
I got a new hammer frag online and since they shipped it overnight, the polyps were pretty much fully open in the bag when it arrived.

Did your frag fully open at the LFS / before you place it into the tank?

I suspect that it has a shock from either accimation or is just getting used to the tank parameters.

Also if you got any hermit crabs, they love bothering corals, espically new ones.
Here after couple days lfs from my town coral is doing better
20260329_224046_9F0DE710-70CB-4A84-9C01-578A7E14C944.png
 

Bleu 3D

New Member
View Badges
Joined
Mar 3, 2026
Messages
16
Reaction score
24
Location
Greenville
Rating - 0%
0   0   0
Your PH being 7.5 is way too low. At that level, corals will start dying. I would get an airstone and air pump or if you have a skimmer with an air intake line, add a CO2 scrubber to it to help oxygenate the tank more. I personally am not a fan of chemical ph buffers because they can swing numbers too fast, throw other parameters out of whack, and potentially do more harm than good. At this point, its sad to say but you will probably lose that coral. Once they get that bad off with only the 1 polyp head, I haven't seen them bounce back. Definitely bring the ph up and try to get your alk closer to 10 dkh to help with ph stability. calcium is a little secondary based on your parameters but ideally it should be 420-450 or a little higher if you run more lps/sps in your tank.
 
OP
OP
J

jerrye

New Member
View Badges
Joined
Mar 25, 2026
Messages
13
Reaction score
4
Location
redding
Rating - 0%
0   0   0
Your PH being 7.5 is way too low. At that level, corals will start dying. I would get an airstone and air pump or if you have a skimmer with an air intake line, add a CO2 scrubber to it to help oxygenate the tank more. I personally am not a fan of chemical ph buffers because they can swing numbers too fast, throw other parameters out of whack, and potentially do more harm than good. At this point, its sad to say but you will probably lose that coral. Once they get that bad off with only the 1 polyp head, I haven't seen them bounce back. Definitely bring the ph up and try to get your alk closer to 10 dkh to help with ph stability. calcium is a little secondary based on your parameters but ideally it should be 420-450 or a little higher if you run more lps/sps in your tank.
20260330_212227_997A6278-602A-4F84-A7B7-237C7DB0A200.png
Coral today water change all I did doing much better adjusted my lighting also
 
OP
OP
J

jerrye

New Member
View Badges
Joined
Mar 25, 2026
Messages
13
Reaction score
4
Location
redding
Rating - 0%
0   0   0
Can add better photos tormrow but it is doing much better water change adjusted my lighting and flow believe it was splitting and stressed doing much better tho thank you everyone for ur input helped a lot
 

TOP 10 Trending Threads

WHAT AMOUNT OF LIVE ROCK AND SAND SHOULD BE PRIORITIZED FOR OPTIMAL BIODIVERSITY/FILTRATION?

  • 100% live rock + bagged sand

    Votes: 34 27.6%
  • 100% dry rock + 100% live sand

    Votes: 43 35.0%
  • 50/50 live/dry rock, 50/50 live/bagged sand

    Votes: 27 22.0%
  • 75% live rock, 25% live sand

    Votes: 11 8.9%
  • 25% live rock, 75% live sand

    Votes: 8 6.5%
Back
Top