So I tink I did bad ting

  • Thread starter Thread starter Suesea
  • Start date Start date
  • Tagged users Tagged users None
Actually he's the one who cut the wrong piece off of my tank to make it bow I'm fixing his mess up. I have an update I will be putting up pictures soon. But he said thanks anyway.
definitely buy a bar clamp and bring the tank edge back to flush. then use weldon and you’ll be golden, definitely use a tape measure to determine when the tank edge is back into alignment BEFORE welding the replacement brace. hell, had an old 55G grow out tank with a broken brace for years with this workaround - back when I was a broke college kid.
 
definitely buy a bar clamp and bring the tank edge back to flush. then use weldon and you’ll be golden, definitely use a tape measure to determine when the tank edge is back into alignment BEFORE welding the replacement brace. hell, had an old 55G grow out tank with a broken brace for years with this workaround - back when I was a broke college kid.
That's exactly what I did all day. I'm leaving it for the night to really harden. Here's a pic. Thanks for your vote of confidence I'm sure it will work too.
20190821_192634.jpg
20190821_192646.jpg
 
That's exactly what I did all day. I'm leaving it for the night to really harden. Here's a pic. Thanks for your vote of confidence I'm sure it will work too.
20190821_192634.jpg
20190821_192646.jpg
you’ll be fine. because I was poor and lazy, my clamp eventually just rusted in place, lol. it wasn’t really a display, so i didn’t care about how ghetto it looked but it worked. i’d leave that clamped for a good 4-5 days. there are plenty of online sources of guidance for how long acrylic needs to fully cure given joint thickness, etc....but it’s at least days and maybe a week or so for a full cure. also, with the clamp there you don’t even need to have the tank drained halfway - good luck and keep us posted
 
you’ll be fine. because I was poor and lazy, my clamp eventually just rusted in place, lol. it wasn’t really a display, so i didn’t care about how ghetto it looked but it worked. i’d leave that clamped for a good 4-5 days. there are plenty of online sources of guidance for how long acrylic needs to fully cure given joint thickness, etc....but it’s at least days and maybe a week or so for a full cure. also, with the clamp there you don’t even need to have the tank drained halfway - good luck and keep us posted
Thank you again, today I have to add more water as its evaporating fast with no lid. I have my routine test today at the hospital till 3:30 :-( I all ready can't wait to work on it some more. I will keep everyone posted. And take pics as well. Tank you
 

TOP 10 Trending Threads

WHAT DO YOU ALWAYS RUN OUT OF AT THE WORST TIME?

  • Salt mix

    Votes: 17 18.9%
  • Fish or coral food

    Votes: 5 5.6%
  • Test kits or reagents

    Votes: 9 10.0%
  • Filter media or replacement fleece

    Votes: 5 5.6%
  • RO/DI filters or supplies

    Votes: 14 15.6%
  • Fragging and repair supplies, like glue or epoxy

    Votes: 10 11.1%
  • I keep a backup of everything

    Votes: 23 25.6%
  • Other (Post in the comments)

    Votes: 7 7.8%
Back
Top
Home
Post thread…
Market
What's new